So after opening the box, I took a look at what was inside. I was quite impressed
how much stuff they managed to fit in such a small box.
The main unit (waterblock, pump and radiator), pre-filled with a 70/30 mix
of water and anti-freeze.
Heatsink mounting clips for Athlon and P4 (Athlon 64 clip coming soon).
20cc Syringe.
Molex to 3pin adapter.
3pin extension lead.
3pin Y splitter.
Thermal grease sachet.
Override ATX power plug.
Override power switch.
Radiator mounting screws and spacers (5).
PCI blanking plate with holes for tubing.
Manual.
Absolutely everything in this box has it's use, maybe not today, but a lot
of these will come in handy over and over again.
Because this unit comes pre-filled, there are two ways of mounting it. Either
install the radiator inside the case, therefore not having to do any bleeding,
or install the radiator outside the case which takes a little longer. Before
doing either of these, lets take a closer look at the unit.
The first thing you may notice, is how small the radiator is.
We'll see how this performs later.
