Random Phrase: Home sweet home...


Read Me First!

This is the Spode's Abode archive. The old articles and forum have been kept here purely for historical purposes and are no longer updated.

Not all portions of this archive may work as expected.


Please visit the new site.



Asetek WaterChill Kit
Written by Allan Nielsen (24/10/03)
Page 2 of 9
Supplied By: Asetek

Untitled Document

I will now guide you through the contents of the WaterChill kit.

Radiator and fan

The WaterChill radiator looks very nice, and seems incredibly sturdy. It is sized for a 120 x 120 mm fan and has holes in both sides for mounting. The fan (Sunon low noise) is fairly loud at 12 volts, but at 7 volts it is much more quiet at the expense of a small cooling performance hit - as you will see later on.


Radiator and fan

Pump, control unit and reservoir

The pump chosen for the WaterChill is a Hydor L20 which seems to be an excellent choice. It is an inline pump, so it does not have to be submerged into a water tank. It is whisper quiet but still pumps 700 l/hr, which is pretty good. It can either be installed with the included rubber feet or with screws. The reservoir is transparent, so you can keep an eye on the water level inside. It's lid makes it easy to fill the system with water.

Asetek recommends that you install the pump and reservoir closely together as you can see below. If you decide to do so, they include a special bracket that slides in between the pump and the pump base plate, and has a small piece of double sided tape in the other end to hold the reservoir. I found this rather inconvenient and it doesn't seem to offer a permanent fixing. However, the hose helps keep it in place, so it is not a huge problem. I added a zip tie to keep things tight, but as I did this after taking the picture below you cannot see the zip tie.


Pump and reservoir

Along with the pump is the control unit. This unit will let you change fan voltage and as you can see from the picture below, all you need to do is set a jumper to select either 7V or 12V. In junction with the hermaphrodite cord, this box will make sure that the pump turns on/off when you turn on/off the computer. The control unit also has pins for an LED, but no LED is included in the kit.


Control unit. Notice the jumper for fan voltage.


Now to the really exciting part - the water blocks!


Here they are, CPU, north bridge and video card blocks.


<< Back | 1 | | 2 | | 3 | | 4 | | 5 | | 6 | | 7 | | 8 | | 9 | Next >>



Copyright Andrew Miller
Please read our disclaimer

Search the site:

Random

Intel Pentium 4 3.2Ghz with HyperThreading (Northwood)